Controlled-products-systems-group 8550C-7 Manual do Utilizador descarregar pdf (Página 20)

Install the Protector System

OPTION B PRE-WIRED INSTALLATION

2.1B Cutthe end of the safety

reversing sensor wire,making

sure there is enough wire to

reach the pre-installed wires

from the wall.

2.2B Separate the safetyreversing sensor wires and strip 7/16 inch (11 mm) of

insulation from each end. Choose two ofthe pre-installed wires and strip 7/16

inch (11 mm) of insulation from each end.Make sure thatyou choose the

same color pre-installed wires for each sensor.

7/16"

(11 mm)

7/16"

(11 mm)

Safety reversing sensor wires

Pre-installed

wires

2.3B Connect the pre-installed wires to the sensor wires with wire nuts

making sure the colors correspond for each sensor.For example,

the white wire would connectto the yellow wire and the white/black

wire would connect to the purple wire.

White

White/Black

Yellow

(for example)

Purple

(for example)

Not Provided

Pre-installed

wires

Safety reversing sensor wires

2.4B At the garage door opener,strip 7/16 inch (11 mm) ofinsulation from each end of the wires previously chosen for the

safetyreversing sensors. Twistthe like-colored wires together.

7/16"

(11 mm)

Yellow

Purple

2.5B Insert the wires connected to the white safetysensor wires to the

white terminal on the garage door opener.Insert the wires thatare

connected to the white/black safetysensor wires to the grey

terminal on the garage door opener.

RED

WHITE

GREY

RED

Purple

(for example)

Yellow

(for example)

To insert or remove the wires

from

the terminal, push in the

tab with a screwdriver tip.

WHITE

GREY

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 81 82

Comentários a estes Manuais

Sem comentários

Controlled-products-systems-group 8550C-7 Manual do Utilizador Página 20

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores Controlled-products-systems-group 8550C-7